How to determine best size Accu-Shot Precision Monopod
Please understand that no monopod will be useful across the wide
range of shooting situations found in the field. The monopod is offered as
an aid, to be used when applicable, not as an answer all. With this in mind,
the best we can hope for is to realize a benefit from the Accu-Shot during
85 - 95% of prone shooting and 95-100% from the bench. There are methods to
increase the application of the Accu-Shot in fluid or dynamic situations
which follow the sizing instructions.
To determine the best monopod for your application the following is
offered as a guideline if using a bipod. If you are using another form of
front rest, the same procedure applies. You will need something to measure
with and a flat level surface.
Set you rifle up on a flat level surface such as a table or shooting
bench with the bipod set at the height you most commonly use. Then hold the
rifle bore as close to level as possible. Then maintain this position of
the rifle while you measure the distance from the point where the monopod
attaches (Rear sling stud position measured from the stock or from the flat
surface of the rail) down to the supporting flat surface. Then the ideal
monopod will give you adjustment on both sides of this measurement.
One consideration you should make is the terrain where you will be using
it, if doing range work, measure it there. If Prairie Dog hunting, then try
to get a measurement on your next trip or reference the rest you used on
your last trip.
If you are Law Enforcement or Military, the BT04 is by far our
most popular model sold to these groups in fact the IDF bought over 800 of
the BT04 with the BT07 Tac-Cap (this cap is steel and adds durability for
hard use units) for their SWS. The following methods will extend the
application of the Accu-Shot Monopod.
Application in Target Rich Environments or Dynamic situations.
Use the leg in a pivoting motion. Grab the knob with the heel of your
hand making contact with the supporting surface. As you move your hand back,
the rifle butt will be raised, when the hand moves forward, the butt is
lowered. Panning is controlled by the same hand at the same time. This
allows for fluid observation and rapid engagements over a wide target area
and full range of elevations including moving targets.
Method to Increase Elevation
When the leg is fully extended and more elevation is required, simply
drop the hand down on the knob, allowing one, two or three fingers to curl
around below the base of the knob will give another 1-1.5” of elevation.
While not as stable as having the knob in contact with the surface, it is a
very solid position.
Shooting from a Barricade position
As the Accu-Shot is not required to support the rifle in this position,
use it in the folded position by placing the bottom of the knob into the
palm of your hand it becomes a “hook” allowing you to control the rifle and
to pull it into your shoulder pocket.
High Angle Shooting
With a bipod deployed and resting on say, a window sill, having the leg
fully extended, the knob becomes an extension of the stock allowing the
operator the ability to hold the knob and completely control the rifle,
gaining the ability to engage targets at very high angles. This method came
from the field, 4 stories high engaged targets on same side of street.
One other item worth mentioning is that in use the rifle is
initially supported by the trigger hand and elbow for initial target
acquisition, during this same time the off hand is deploying the monopod
leg. Once the target is acquired the Accu-Shot leg is quickly adjusted until
it touches the deck, the rifle is then rested on the monopod. Then the
operator makes finial adjustments into the precise sight picture. It is
best to never remove your off hand from the Accu-Shot monopod leg while
firing the weapon. Use it to control the sight picture while the other hand
controls the feeding (where required) and trigger. It is not a good
practice to adjust the monopod leg to get the perfect sight picture, then
removing you hand to hold the rifle stock in another area. Try keeping you
hand on the monopod leg, with the recoil pad firmly in your shoulder pocket
while concentrating on the trigger break. With practice you will find
yourself ready to go to trigger just as quick as the action is locked.
